User's Manual

30
Remote device
Click Device Search.
The searched devices are displayed.
Enable Uninitialized function.
The uninitialized devices are displayed.
Select the check box the uninitialized device, and then click Initialize.
The Password Setting interface is displayed.
Configure the password by either of the following two ways.
 Using current device password and phone info. Select the Using current device
password and phone info check box, and the remote device uses the
password and phone info of the Device.
 Manually configure password for remote devices.
1) Clear the Using current device password and phone info check box.
The password setting interface is displayed.
2) In the New Password box, enter the new password and enter it again in the
Confirm Password box. Click Next.
The Password Protection interface is displayed.
3) Set up password protection.
◇ Select the Phone No. check box, and then enter the phone number. Click
Next.
◇ Click Skip if you do not want to set up password protection.
The Network interface is displayed.
Configuring network information.
 Set up the network information of the remote device according to your network
plan, and click Next.
◇ Select Static, and manually set up the IP address, subnet mask, and
gateway of the remote device. If selecting multiple devices, you can set up
the IP address to increase in turn.
◇ When there is a DHCP server in the network, select DHCP, and the Device
obtains IP addresses from the DHCP server automatically.