User's Manual

29
Name
Description
Server
In the Timing Mode list, if NTP is selected, configure this
parameter
After configuring NTP server, the Device syncs time with NTP
server
3. In the Timing Mode list, select NTP to enable the NTP
timing function
4. Configure parameters
 Server: Enter IP address of NTP server
 Synchronize: Click Synchronize
to sync the Device
time with NTP server
 Port: The system supports TCP protocol only and the
default setting is 123
 Interval: Enter the interval that you want the Device to
sync time with the NTP server. The maximum value is
65535 minutes
Synchronize
Port
Update Period (minute)
Click Apply.
4.3.3 Configuring Remote Devices
Remote devices refer to IPC, dome, and other equipment that can be connected to the
Device through network. The system supports initialization, remote device adding, etc.
4.3.3.1 Initializing the Remote Device
Initializing the remote device includes configuration of login password and IP address for the
remote device. Add and operate a remote device after initialization of the remote device.
 The Device automatically initializes the IPC and the system uses the device password
and phone information by default after IPC is connected to the Device through a PoE
port.
 The Device initialization might fail after IPC is connected to the Device with an upgraded
system version through a PoE port. Initialize the IPC on the Remote Device interface.
Right-click Remote Device on the main interface.
The Remote interface is displayed. See Figure 4-10.