User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
18
Four-cored aviation port
No.
Function
1
12V external power source and no more than 1.5A.
2 Ground line
3 Audio port
4 Video port
Video Output
The Device is provided with one CVBS (PAL/NTSC 1.0V
P-P
, 75Ω) port and VGA port, and
supports the simultaneous output from these two ports.
Read the following contents carefully before using the computer instead of monitor.
For VGA output, you need to prepare a VGA adapter cable to connect to computer.
To extend the Device life, do not keep the Device running for a long time.
Regular demagnetizing helps keep the monitor working properly.
Stay away from devices with strong electromagnetic interference.
Audio output
The audio output signal parameter is larger than 200mv 1KΩ. The audio output port can directly
connect to the display with audio function on the vehicle or active speaker, and the port can
also drive other sound output devices through amplifier.
Alarm Input and Output Connection
Before using the alarm function, learn about the connections method of alarm input and output
port.
Alarm Input
The alarm input port supports alarm signal from ground and device of 12V-24V voltage.
If the alarm device is connected to the Device and other devices, use relay for isolation.
Alarm Output
The alarm output port cannot be connected to high-power load (less than 1A). When
constructing the output circuit, the excessive current should be prevented from causing
damage to the relay. Use the contactor for isolation when applying high-power loads.