User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
14
2.3.3.1 Installation of Mobile Network Antenna
CAUTION
When installing sticking antenna, make sure there is no metal material below the sticking spot.
For installation of mobile network antenna, see Figure 2-17. The flat antenna is recommended
to be vertically attached to near the wind shield (such as on the instrument panel, or under the
wind shield), or concealed inside the instrument panel.
Inside installation of Mobile Network Antenna
2.3.4 Fixing the Device
CAUTION
Install the Device on the vehicle where it cannot be seen from outside. Avoid places with
high temperature or near the air conditioning system. High temperature shortens the life of
the Device. If going into the Device, the condensing water from the air conditioner can
short circuit or burn the Device.
Power on the Device only after all external devices are connected correctly to the Device.
Install lugs onto the Device.
1) Place washers onto the fixing screw.
2) Use fixing screws with washers, mount lugs to the bottom of the Device
respectively, and tighten the lugs.
Install the lugs onto the Device.
Fix the device onto the vehicle.
1) Punch holes on the vehicle according to the installation dimensional drawing.
2) Use screws to fix the Device onto the vehicle.