User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
200
5.7.3.4 Configuring auto shutdown system
After configuring auto shutdown, the Device automatically shuts down according to the ACC
power off time and auto boot up setting.
If you have set the time for auto boot up, there are two situations when the ACC is powered
off: If the system time is between the auto boot up and auto shutdown, the Device is turned
off at the configured time. If the system time is before the auto boot up or after the auto
shutdown, the Device is turned off immediately.
If the auto boot up is not set, when the ACC is disconnected, the Device shuts down at the
scheduled time.
Select Setting > System > Auto Maintain.
The AUTO MAINTAIN interface is displayed.
In Auto Shutdown System, select Everyday, and then enter the specific time.
Click Save.
5.7.3.5 Auto Delay for Shutdown
After configuring auto delay for shutdown, when ACC is disconnected, the Device shuts down
according to the settings of auto delay for shutdown.
If you enter the delay value that is not 0, the Device automatically shuts down after the
preset delay.
If you enter 0, the Device shuts down according to the auto shutdown settings without
delay.
Select Setting > System > Auto Maintain.
The AUTO MAINTAIN interface is displayed.
Configure the auto delay for shutdown.
The value ranges from 0 through 65535. The default value is 5 minutes.
Click Save.
5.7.4 Backing Up and Restoring
You can back up or restore the web configurations and restore to default settings.
5.7.4.1 Backing up Configurations
You can back up all the configurations of web.
Select SETUP > SYSTEM MANAGEMENT > CONFIGURE BACKUP.
The Import/Export interface is displayed, see Figure 5-99.
Import/Export
Click Config Export, and select the save path.