User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
178
Select alarm output mode.
Manual: After the alarm linkage is configured, no matter whether there is an alarm
event occurs, the corresponding alarm output port keeps generating alarm.
Auto: After the alarm linkage is configured, when an alarm event occurs, the
corresponding alarm output port generates alarm.
Stop: After the alarm linkage is configured, no matter whether there is an alarm
event occurs, the corresponding alarm output port never generate alarm.
Click Save.
Status: Indicates the status of each alarm output port. Indicates there is an alarm
output, and indicates there is not.
5.5.4 Managing storage device
Configure HDD storage, package basic information, manage HDD, and review HDD
information.
5.5.4.1 HDD Management
Set up the read/write properties of HDD and review HDD capacity.
Select Setup > Storage Management > HDD Management. The HDD Management interface
is displayed. See Figure 5-67.
You can set up the HDD as the read/write disk and redundancy HDD on the HDD Operation
column.
Read/Write: Read HDD data and save data to HDD.
Redundancy HDD: If more than two HDDs are connected to the device or SD card, one
HDD can be set to the redundancy HDD for recording backup.
Select the HDD and click Formatting to clear all data from the HDD. Proceed with caution.
Storage Device
5.5.4.2 Viewing HDD Information
You can view the HDD information, time period of recording files, and Smart information.
Select INFO > INFO > HDD. The HDD interface is displayed. See Figure 5-68.
Double-click the HDD. The SMART interface is displayed. See Figure 5-69. On this
interface, you can find the name, model, serial number, healthy status, and details about
the HDD.
Click the HDD Time to view the record information in the HDD.