User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
170
Device management
2) Click , initialize the device as needed and follow on-screen instructions to
connect the device. To do so, you can scan the device label or the serial number
QR code of the device on the device page.
After scanning, the device is added. The serial number of the device is displayed in
Serial Number section.
To review the monitoring image of the device, click Start Preview.
5.5.3 Set alarm information
You can configure the alarm settings such as video detection, alarm events, abnormality, and
alarm output.
5.5.3.1 Configuring Video Detection Settings
Video detection includes motion detect and tampering. This function detects abnormal video
images.