User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
166
FTP setting
Select Enable to enable FTP upload.
The system selects SFTP by default. It is recommended to keep this default setting.
When selecting FTP, the system gives a risk prompt. Select Save or Cancel based on
your needs.
Configure TCP/IP parameters. For details, see Table 5-26.
Table 5-23 FTP parameter description
Name
Description
Server IP The IP address of the PC that is installed with the FTP/SFTP server
Port The default value is 21
Username
The username and password used to access the server
Password
Anonymous
Select Anonymous if you want to login to the server anonymously
Remote
Directory
Create folder on FTP server
If you do not enter the name of remote directory, the system
automatically creates the folders according to the IP, time, and channel
If you enter the name of remote directory, the system creates the folder
with the entered name under the FTP/SFTP root directory first, and
then automatically creates the folders according to the IP, time, and
channel