User's Manual

161
offline until the total power of the camera accessed through PoE does not exceed the maximum
power of the device.
PoE management
5.5.2 Network Parameters Configuration
Set up the network parameters of the device as needed. This includes setting up the port, , 3G
parameters, Email, FTP, active registration, P2P and SWITCH.
5.5.2.1 Connection Setting
Configure the maximum port numbers and values.
Select Setup > Network > Connection Setting.
The Connection Setting interface is displayed. See Figure 5-51.
Port
Configure the port parameters of the device. For details, see Table 5-23.
NOTE
The revised settings take effect after reboot. Proceed with caution.
Table 5-20 Connection setting parameters description
Name
Description
TCP
Port
Transmission Control Protocol port, the value is 37777 by default
UDP
Port
User Datagram Protocol. The default value setting is 37778. You can enter the value
according to your needs
HTTP
Port
Hyper Text Transfer Protocol port. The default setting is 80. You can enter the value
according to your actual situation, and in this case, add the modified value after the
address when logging the Device on the browser