User's Manual

160
5.5.1.2.4 Path
You can configure the storage path of captured snapshots and recorded videos.
Select SETUP > CAMERA > ENCODE > Storage Path.
The Path interface is displayed, see Figure 5-48.
Path
Click Browse to select the save path for snapshots and records.
On the PREVIEW interface, images and recordings taken by snapshot and
recording are saved in the following paths by default: Default paths:
C:\PictureDownload and C:\RecordDownload
Click Save.
5.5.1.3 Configuring Channel Name
You can configure the channel name for the corresponding device.
Select SETUP > CAMERA > CHANNEL NAME.
The CHANNEL NAME interface is displayed. See Figure 5-49.
Channel Name
Configuring Channel Name
Click Save.
5.5.1.4 Configuring PoE
Review the connection status of the PoE port and reset the camera.
Select Setup > Camera > PoE. The PoE Management interface is displayed. See Figure 5-50.
Select PoE Reset, and click Apply to reset the camera with power but offline so that the
camera can be online. If the camera is still offline after reset for 3 times, the system will not
reset again.
When the total power of the cameras accessed through PoE exceeds the maximum power of
the device, the device will force the camera connected to the maximum port number to go