User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
154
Alarm
Select alarm type.
Select prompt, and the system prompts and records alarm information as needed.
If you are not at the Alarm interface when the selected alarm is triggered, there will
be a displayed on the Alarm tab and the alarm information will be recorded.
Click the Alarm tab, and the sign disappears.
If you are at the Alarm interface when the selected alarm is triggered, there will be
detailed alarm information displayed at the right side of the interface.
(Optional) Set the alarm sound as needed and the preset alarm sound will be played
when an alarm is triggered.
1) Select the Play Alarm Sound.
2) Click Select to select the alarm sound file.
System Settings
NOTE
In this section, when you have configured the settings for a channel, click Copy to apply the
configurations to other channels. Click Refresh to display the latest configuration. Click Default
to restore to factory default settings.
5.5.1 Configuring lens parameter
Configure the image property, encoding parameter, and corresponding channel name of the
remote device.
5.5.1.1 Configuring Image Properties
Set up the image property parameters of the channel.
NOTE
Different cameras correspond to different image parameters. Follow actual parameters.
Select SETUP > CAMERA > Camera.
The Conditions interface is displayed.
Select a channel.