User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
5
No.
Name
Function
1 CH1-4
Connects to HDCVI or analog mobile camera, such as CVBS,
TVI, and AHD. Refer to "2.2.3.1 CH1-4 Port" for details.
NOTE
Different devices corresponds to different number of channels
2 ETH interface
The aviation port can be converted to an RJ45 interface through a
adapter cable.
Access to PoE power switch to realize IPC remote access.
Connects to the network to realize the login and Web
interface operation of the Device.
3 AV OUT port
Connects to the display with audio function on the vehicle for
simultaneously video and audio data output. For details, see “2.4
Audio and Video Output Connection.”
4 VGA port
Outputs analog video data to the connected display with VGA
port. For details, see "2.2.3.3 VGA Port."
5 Power cable
Connects to 6V DC–36V DC power for power supply from vehicle
battery. See "2.2.3.2 Power Input" for details.
The red end with fuse is the anode of the power supply
(always-live wire)
The black wire is the ground wire
The orange one is the ACC signal (key starting wire)
6
Positioning
antenna port
Connects with positioning antenna for receiving satellite
positioning signals
NOTE
This function is supported on the Device with positioning module
8 3G antenna port
Connects to 3G antenna for receiving 3G signals.
NOTE
This function is supported on the Device with 3G modules.
9 Voice talk port
Connects to voice talk device. For details, see “Voice Talk Port”
introduction.
10
External pickup
port
Connects to external pickup. For details, see “External pickup
port” introduction.
11 EXTEND port See “EXTEND Port” introduction.
12 ALARM/485/232
Alarm input/output port: Includes alarm input/output port,
grounding, and 12V output port. For details, see “
2.5Alarm
Input and Output Connection.”
TX,RX: RS-232 port sender and receiver that connect to
RS-232 port.
A, B: Controls PTZ operations.
2.2.3 Interface definitions
NOTE
This Manual only describes functions of all jacks of each interface. You can follow these
descriptions to prepare cables or contact our sales staff for purchasing cables.