User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
146
5.4.1.6 Multi-channel preview
After the multi-channel preview is enabled, the output image is compressed to combine multiple
channels in the local interface to one channel. Then you can view multiple channels from
remote access, and save much of the network transmission bandwidth.
Select a channel, and then select the split mode from . Then you can
view the multiple channel views in one channel. See Figure 5-33.
Multi-channel preview
5.4.2 Video playback
On the PLAYBACK interface, you can play back and download recorded video files.
Click Playback tab, and the Playback interface is displayed. See Figure 5-34.