User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
135
Record Plan
Configure TCP/IP parameters. For details, see Table 5-6.
Table 5-6 Record schedule parameters description
Name
Description
Channel
Select a channel to configure the corresponding recording schedule. To
configure the same setting for all channels, select All
Pre-record
Start recording for 0 seconds to 30 seconds before the alarm event occurs. If
you enter 0 seconds, there will be no pre-recording
Configure the recording time period.
1) Click Setup corresponding to the week.
The Settings interface is displayed. See Figure 5-17.
Settings
2) Select the record type and weekday, and enter the recording period.
NOTE
If the MD check box and the Alarm check box are selected, the corresponding
alarm linkage should be enabled. For details, see 5.5.3Set alarm information. For