User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
129
Remote device
Click Device Search.
The searched devices are displayed.
Select the Uninitialized check box.
The uninitialized devices are displayed.
Select the check box the uninitialized device, and then click Initialize.
The password setting interface is displayed. See Figure 5-10.
Password setting
Configure the password by either of the following two ways.
Using current device password and phone info. Select the Using current device
password and phone info check box, and the remote device uses the password
and phone info of the Device.
Manually configure password for remote devices.
1) Clear the Using current device password and phone info check box.
The password setting interface is displayed. See Figure 5-11.