User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
126
Name
Description
Default
gateway
NOTE
IP address and gateway must be in the same network segment
Preferred
DNS
IP address of the preferred DNS
Alternate DNS IP address of the alternate DNS
MTU
Displays the MTU value of the Ethernet card. The default setting is 1500
bytes and cannot be changed
Click Save.
5.3.2 Configuring General Settings
You can configure the basic settings, including time and date settings.
5.3.2.1 Setting General Information
Set up the general information of the Device, including video recording strategy when the HDD
is full, recording length, menu standby duration, license plate, and more.
Select SETUP > SYSTEM > GENERAL > General.
The General interface is displayed, see Figure 5-7.
General
Configure TCP/IP parameters. For details, see Table 5-2.
Table 5-2 General settings parameters description
Name
Description
Language Select a language for the Device system
Video
standard
Displays the video encode standard