User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
125
Preconditions
Make sure the Device is connected to the network properly.
Steps
Select Setup > Network > TCP/IP.
The system displays the TCP/IP interface, as shown in Figure 5-6.
TCP/IP
Configure TCP/IP parameters. For details, see Table 5-1.
Table 5-1 TCP/IP parameter description
Name
Description
IP Version
Select IPv4 or IPv6. Both versions are supported
NOTE
For IPv6 version, in the IP address box, Default Gateway box, Preferred
DNS
box, and
Alternate DNS
box, enter 128 bits and cannot be blank
MAC address Host’s MAC address, cannot be modified
Mode
Static
You need to manually configure IP Address, Subnet Mask and Default
Gateway
DHCP
Obtains IP address automatically With DHCP enabled, IP Address,
Subnet Mask and Default Gateway cannot be configured
You can check the current IP address whether the DHCP takes effect or
not
IP address
According to your network plan, enter the modified IP address, gateway and
subnet mask
Subnet Mask