User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
105
Position report (device auto)
2. Configure TCP/IP parameters. For details, see Table 4-30.
Table 4-30 Device auto report parameters description
Name
Description
Report Interval
When the vehicle ACC status is on, the system report the position
to platform according to the configured report interval, report
distance, and inflexion angle
The system reports vehicle position to platform only if one of
conditions is satisfied
Report by Distance
Inflexion Angle
Report Interval When
ACC off
When the vehicle ACC status is off, the system report the position
to platform according to the configured report interval
Platform schedule.
In the Report Strategy list, select Platform Schedule. The Platform Schedule
setting interface is displayed. See Figure 4-90.
The platform obtains the device position by the configured schedule. The
schedule is configured at the Platform. See the User's Manual of the platform.