User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
94
Add group
Configure TCP/IP parameters. For details, see Table 4-22.
Table 4-22 Description of group parameters
Name
Description
Group name
Setting up group name
The group name can be set to a maximum of 64 characters and may
contain letters, numbers and special symbols (including “_”, “@”, “.”).
Remarks
Setting up note info.
Click the System, Playback or Monitor tabs respectively to set user group
permissions.
TIPS
Select All to select all permissions under this category.
Click OK.
Related Operations
After adding user groups, user group information can be edited and user groups can be
deleted. Refer to Table 4-23 for details.
Table 4-23 Related Operations
Function
Operation
Edit user group
info
Click to edit group info.