User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
89
You can set up the HDD as the read/write disk and redundancy HDD in the Type column.
Read/Write: Read HDD data and save data to HDD.
Redundancy HDD: If more than two HDDs are connected to the device or SD card, one
HDD can be set to the redundancy HDD for recording backup.
Select the HDD and click Formatting to clear all data from the HDD. Proceed with caution.
Disk management
4.6.4.3 Setting FTP storage
Back up recorded videos and images to the preset FTP (File Transfer Protocol) server for
storage.
Preconditions
Make sure you have purchased or download a FTP server and installed it on your PC.
NOTE
For the created FTP user, you need to set the write permission; otherwise the upload of
recorded videos and snapshots will be failed.
Steps
In the main menu, select STORAGE > FTP.
The FTP interface is displayed, see Figure 4-73.