User's Manual

This device complies with FCC part 15C: 15.247 and 15.407.
This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter. The module should be installed at a minimum
distance of 20 cm away from a person nearby. The host product manufacturer should state
this information to the host instruction manual.
Trace antenna designs - not applicable.
Any final host product with the modular transmitter installed should be under
test according to guidance given in KDB 996369 D04. To enter test mode for module,
secure CRT command is necessary. When something wrong happens in configuring test modes
for host product with module, host product manufacturer should coordinate with module
manufacturer for technical support. It is recommended that some investigative
measurements should be taken to confirm that host product with module installed does not
exceed the spurious emissions limits or band edge limits.
The modular complies with FCC authorised for the specific rule parts (FCC Part
15.247 and 15.407) list on the grant, and that the host product manufacturer
is responsible for compliance to any other FCC rules that apply to the host not
covered by the modular transmitter grant of certification. The final host product
still requires Part 15 subpart B compliance testing with the modular transmitter
installed when contains digital circuity.
The device is going to be operated in 5150~5350MHz frequency range. It
is restricted indoor environment only.
The end product must carry a label stating "Contains FCC ID: SVN-
M8822CU1" or shall use e- labeling.
Manufacturer's name and address: SHENZHEN BILIAN ELECTRONIC CO.,LTD
10~11/F, Building 1A, Huaqiang idea park, Guangming district, Shenzhen.
Guangdong, China