User's Manual

User’s Manual
8
4 Radar Configuration on Camera Web
Install the Radar (see "3 Installation"), connect the Radar to camera (see "2.3 Cable"), and
then set the radar parameters on the web interface of camera, so the Radar can work with the
camera to detect and capture vehicles.
Open the browser, enter the IP address of the camera in the address bar, and then Step 1
press the Enter key.
Enter the username and password, and click Login to log in to the web interface of Step 2
the camera.
Select Setup > ITC > Intelligent > Radar. Step 3
Radar
Figure 4-1
Select Enable Radar to enable radar detection, and then you can configure the Step 4
parameters.
 This section takes ITARD-024SA-ST radar as an example.
 The interface is for reference only, and the actual interface shall prevail.
Table 4-1 Radar description
Parameter
Description
COM SET
COM Port
Select the corresponding COM port. COM1/2/3 corresponds to Lane1/2/3
respectively. Select according to the actual lane that the Radar detects.
Radar Type
Select the radar type according to the actually-connected radar.
Parameters of the selected radar need to be configured at the right side of
the interface.
ITARD-024SA-ST