Quick Start Guide

Quick Start Guide
7
Figure 5-2 Install the bracket
7. A
ttach the camera to the mounting bracket using the threaded insert at the rear of the camera.
Rotate the camera clockwise until attached, then tighten into place with the adjustable nut.
Figure 5-3 The back of wall mounting bracket
8. A
djust the camera to the desired angle.
If the camera is not holding in place or difficult to adjust, unplug the camera and slide the bracket
up to detach from the mounting plate. Tighten or loosen the 3 screws at the back of the
mounting bracket to adjust accordingly. Repeat steps 4-6 to re-install.