User Manual

ii
Important Safeguards and Warnings
1᧪
᧪᧪
᧪Electrical safety
All installation and operation here should conform to your local electrical safety codes.
We assume no liability or responsibility for all the fires or electrical shock caused by improper handling
or installation.
We are not liable for any problems caused by unauthorized modification or attempted repair.
2᧪
᧪᧪
᧪Installation
This series product shall be installed one or three meters away from the lane. The default angle
between the radar and the road is 22°(The error val ue shall be less than or equal to ±1° ). The produc t
shall face the road .The road shall be plain and no turning point.
Changes or modifications not expressly approved by the party responsible for compliance, void the
user's authority to operate the equipment.
3᧪
᧪᧪
᧪Environment
It shall be installed away from the large-size metal object or strong magnetic area.
4. Lithium battery
Improper battery use may result in fire, explosion, or personal injury!
When replace the battery, please make sure you are using the same model!
5. FCC INFORMATION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device not cause harmful interference,
(2)This device accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.