User Manual


17
Figure 3-7
Note:
Installation distance: Set first lane distance from location where the device locates. This shall be
based on actual distance. Recommend 150cm.
Lane width: Set lane width. Based on actual lanes, and do not fill in extra lanes. For example, is
lane quantity is e, then leave 4
th
, 5
th
and 6
th
lanes empty. Default is 0 cm.
3.2.5.2 Camera Setting
The camera setting interface is shown as below. See Figure 3-8.
z Exposure mode: There are two options: fixed and auto.
z Video exposure: Default is level 6 as 4ms.
 In the fixed mode, it includes seven options: 100ȝs /250ȝs /500ȝs
/1ms/2ms/4ms/8ms/20ms. You can use the “+” and “-” to set the time.
 In the auto mode, you can use the small keyboard to set the exposure time. The value
ranges from 0 ~120000ȝs. Default is 0~4000ȝs.
z Preview value: Brightness threshold. Flashlight is enabled when lower than this value.
z Flash mode: There are three modes: doe not flash, always flash and auto flash.
z Frame interval: There are three modes: 0, 1 and 2.
z Snap times: You can select to snapshot 1 or 2.
z Day/Night mode: There are three modes: color, auto and B/W.
z Auto gain: There are two modes: auto and fixed.