User Manual


16
3.2.5 Config
3.2.5.1 Radar Setting
The radar setting interface is shown as in Figure 3-6.
z Low limit: Set to enable/disable low speed measuring and snapshot. You can set low limit
after enabled.
z Low value: Set value of low limit. When vehicle in area is slower than this value, snapshot is
on.
z Large or small: There are two options: disable/enable. There are two trigger speeds for the
large and small vehicle respectively if you check the enable button here. The interface is
shown as in Figure 3-7.
 Disable: Only display speed limit and trigger value.
 Enable: Display truck limit, truck trigger, low limit and low trigger.
z Truck limit: You can input the truck limit here.
z Truck trigger: You can input the snapshot trigger value for the large vehicle here.
z Radar angle: Input speed measuring system installation angle. The angle must match actual
angle. Recommended angles are 22°(approaching), 25° (departing) and 25°both).
z Direction: It includes three direction modes:
 Approaching: The system snapshot the vehicle head.
 Departing: The system snapshot the vehicle rear.
 Both: System snapshot both the head and rear.
z Sensitivity: Here is to set radar sensitivity. There are four levels. The fourth level has the
highest sensitivity. The default setup is level 3.
Figure 3-6