Users Manual

234
Figure 5-7
Step 4 Follow the prompts on the interface and then scan the QR code to get the security code.
WARNING
 For the same QR code, max scan twice to get two security codes. Refresh the QR code if
you want to get security code again.
 The security code on you email is only valid for 24 hours.
 After five times security code failure, the admin account will be locked for 5 minutes.
Step 5 Input the security code on the email and then click Next button.
Step 6 Input new password and then confirm.
WARNING
The password can be set from 8 characters through 32 characters and contain at least two types
from number, letter and special character (excluding"'", """, ";", ":" and "&"). It is recommended to
set password of high security according to the prompts.
Step 7 Click OK button to complete the setup.
5.5 LAN Mode
For the LAN mode, after you logged in, you can see the main window. See Figure 5-13.
This main window can be divided into the following sections.
 Section 1: there are six function buttons: Live (chapter 5.6), setup (chapter 5.11), info (Chapter 5.12),
playback (chapter 5.13), alarm (chapter 5.15), and logout (chapter 5.16).
 Section 2: There are monitor channels successfully connected to the NVR.
Please refer to Figure 5-8 for main stream and extra stream switch information.