Product Info

179
Figure 4-180
Step 2 Select the SNMP check box.
Step 3 Configure the parameyers. For details, see the following table.
Parameter Description
Version
Select the check box of the corresponding version.
System selects V3 by default. There might be risks for V1 and V2.
SNMP Port Enter the SNMP port number.
Read
Community/Write
Community
The read community/write community string supported by the program.
Trap Address
Enter the IP address of the PC installed with MG-SOFT MIB Browser. It
is the destination address to receive trap information from the device.
Trap Port The destination port to receive trap information from the device.
Read Only User Enter the read only username to access the NVR device.
Read/Write User Enter the read/write username to access the NVR device.
Authentication
It includes MD5 and SHA. System automatically recognizes it after it is
enabled.
Password
Enter the password for encryption and authentication. The password
shall be no less than 8 characters.
Encryption Type Select the encryption type. The default type is CBC-DES.
Step 4 Click OK to complete the configuration.
Step 5 View device info.
1) Run MIB Builder and MG-SOFT MIB Browser.