User's Manual

87
Parameter
Description
Host IP
Displays the IP address of AP.
Step 3 Click Save.
Result
1. Open your device such as mobile phone, search for the network name of the AP in the wireless
signal list, and then connect to the network.
After it is successfully connected, the IP address and MAC address of the device is displayed on the
AP interface.
2. Open a browser on your device, enter the host IP on the AP interface or IP address on the TCP/IP
interface, and then you can go to the login interface of the Camera.
3. Enter the username and password, and then log in to the Camera.
Live view is available on select devices.
5.2.12 802.1x
802.1x is a port-based network access control protocol. It allows users to manually select
authentication mode to control device access to LAN, and meet authentication, billing, safety and
management requirements of the network.
Step 1 Select Setting > Network > 802.1x.
Figure 5-53 802.1x ipage
Step 2 Select the Enable checkbox to enable 802.1x.
Step 3 Select an authentication mode, and then enter username and password.
Table 5-22 Description of 802.1x setting parameter
Parameter
Description
Authentication
PEAP (protected EAP protocol).
Username
The username that was authenticated on the server.
Password
Corresponding password.
Step 4 Click Save.