User's Manual

86
5.2.11.2 WPS Settings
Figure 5-51 WPS settings
PIN and SSID can be obtained from the router. Enter PIN and SSID, and then click Refresh to display
operating status in real time.
5.2.11.3 AP Settings
You can use the Camera as wireless AP (Access Point), and other devices such as mobile phones can
connect to the Camera by searching for the network name. You can then log in to the Camera
through the browser on your device. At most 5 accounts can log in to the Camera at the same time.
AP and Wi-Fi cannot be both enabled at the same time, and AP is disabled by default.
Procedure
Step 1 Select Setting > Network > WIFI > AP.
Step 2 Select Enable, and then set AP information.
Figure 5-52 AP settings
Table 5-21 AP parameter description
Parameter
Description
SSID
The default name is "device serial number_SD".
Frequency Band
Both 2.4G and 5G are available.
Verification Type
It is WPA2 PSK by default, and cannot be changed.
Connection Password
Set the connection password which is required when other devices
connect to the Camera. It is 12345678 by default.