User's Manual

84
5.2.10 Auto Register
After you enable this function, when the Device is connected to Internet, it will report the current
location to the specified server which acts as the transit to make it easier for the client software to
access the Device.
Step 1 Select Setting > Network > Auto Register.
Figure 5-47 Auto register
Step 2 Select the Enable checkbox to enable Auto Register.
Step 3 Enter IP Address, Port and Sub-Device ID.
Table 5-20 Description of auto register parameter
Parameter
Description
IP Address
The IP address of server that needs to be registered to.
Port
The port for auto-registration.
Sub-Device ID
Sub device ID assigned by server.
Step 4 Click Save.
5.2.11 Wi-Fi
Devices with Wi-Fi function can access network through Wi-Fi.
● Wi-Fi and WPS are available on select models.
● All devices with WPS button support WPS function.
5.2.11.1 Wi-Fi Settings
The name, status and IP information of current hotspot are displayed in the Wi-Fi information bar.
Click Refresh after reconnection to make sure that the operating status is displayed in real time.
Connecting Wi-Fi hotspot takes some time depending on network signal strength.
Step 1 Select the Enable checkbox.