User's Manual

Use PC with Windows OS and disable SNMP Trap service. The MG-SOFT MIB Browser will display

prompt when an alarm is triggered.

5.2.9 Multicast

You can access the Device by network to see live view. If the access times exceed its upper limit,

preview might fail. You can set multicast IP to access by multicast protocol to solve the problem. The

Device supports two multicast protocols: RTP and TS. RTP is enabled by default when main stream

and sub stream are used. TS is disabled by default.

5.2.9.1 RTP

Step 1 Select Setting > Network > Multicast > RTP.

Figure 5-45 RTP page

Step 2 Enable main stream or sub stream.

Step 3 Enter multicast address and port number.

Step 4 Click Save.

5.2.9.2 TS

Step 1 Select Setting > Network > Multicast > TS.

Figure 5-46 TS page

Step 2 Enable main stream or sub stream.

Step 3 Enter multicast address and port number.

Step 4 Click Save.