User's Manual

73
Parameter
Description
RTMP
A network protocol for real-time data communication. The value is 1935 by
default. You can enter the value as needed.
Enable RTMP to push audio and video data to the third-party server. Make
sure that the address is trusted; otherwise it might cause data leakage.
HTTPS Port
HTTPS communication port. The value is 443 by default. You can set this
parameter as needed.
5000 Port
The port is disabled by default. If you need to connect the Camera to
intelligent transportation box through 5000 port, enable this port.
There might be network risk if the port is enabled. Be cautious.
Step 3 Click Save.
5.2.3 PPPoE
You can enable PPPoE (Point-to-Point Protocol over Ethernet) to establish network connection. In
this case, the Device obtains a dynamic IP address. To use this function, you need to obtain the PPPoE
username and password from the Internet Service Provider (ISP).
Step 1 Select Setting > Network > PPPoE.
Figure 5-37 PPPoE page (1)
Step 2 Select Enable, and then enter PPPoE username and password.
Step 3 Click Save.
Save Succeeded! is displayed, and the obtained IP address of public network is displayed in
real time. You can access the Device through the IP address.