User's Manual

71
System
Command
UNIX/Linux/Mac syntax
arp -s <IP Address> <MAC>
ping -s 480 < IP Address >
Example:
arp -s 192.168.1.125 11-40-8c-18-10-11
ping -s 480 192.168.0.125
Win7 syntax
netsh i i show in
netsh -c“i i” add neighbors ldx <IP Address> <MAC>
ping -l 480 -t < IP Address >
Example:
netsh i i show in
netsh -c“i i” add neighbors 12 192.168.1.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.1.125
Step 4 Power off the Device and then restart it, or restart the Device over the network.
Step 5 Check the PC command line. If there is information such as "Reply from 192.168.1.125…", it
means the configuration succeeds. In this case, you can close the command editor.
Step 6 Enter http://<IP address> in the browser address bar to log in.
5.2.2 Port
You can configure the maximum port numbers and values on this page.
Step 1 Select Setting > Network > Port.
Figure 5-36 Port page
Step 2 Configure each port value of the Device.