User's Manual

69
Parameter
Description
IP Version
You can select IPv4 or IPv6. Both versions are supported and can be
accessed.
IP Address
Enter correct digits to change the IP address.
Subnet Mask
Set the subnet mask according to actual conditions. The subnet
prefix is a number in the range of 1 to 255. The subnet prefix
identifies a specific network link, and usually contains a hierarchical
structure.
The Device checks the validity of all IPv6 addresses. The IP address
and the default gateway must be in the same network segment.
Make sure that a certain part of the subnet prefix in the IP address
and default gateway are the same.
Default Gateway
Configure as needed. The default
gateway must be in the same
network segment as the IP
address.
For IPv6 version, in the IP
Address, Default Gateway,
Preferred DNS, and Alternate
DNS fields, enter 128 bits, and
these fields cannot be blank.
Preferred DNS
IP address of the DNS server.
Alternate DNS
Alternate IP address of the DNS
server.
MTU
You can set the MTU value to ensure good data transmission
according to the network. The value is 1500 by default. Modifying
MTU value causes Ethernet card restarting and network
disconnection.
Here are some suggested values for your reference.
● 1500: It is the maximum and default value of Ethernet packet,
typical setting of the network connection without PPPOE or
VPN, and is the default setting of some routers, network
adapters, and switches.
● 1492: The optimal value for PPPOE.
● 1468: The optimal value for DHCP.
● 1450: The optimal value for VPN.
Enable ARP/Ping to set IP
address service
Select the checkbox, and then you can modify and set the device IP
address through ARP/Ping command if the MAC address is known.
● The function is enabled by default. During reboot, you will have
no more than 2 minutes to configure the Device IP address by a
ping packet with certain length.
● The server will be turned off in 2 minutes, or it will be turned off
immediately after the IP address is successfully configured. If
the function is not enabled, the IP address cannot be configured
with ping packet.
Step 3 Click Save.
Related Operations
An Example of Configuring IP Address with ARP/Ping