User's Manual

45
Figure 5-9 Day & night settings
Step 2 Configure day & night parameter.
Table 5-3 Description of day & night parameter
Parameter
Description
Type
There are two options: Electrical and ICR. ICR is selected by default.
Electrical Image processing method is used for day & night switch.
ICR: IR filter is used for day & night switch.
Mode
Select a mode from the list (Your selection is independent from the profile).
Auto is selected by default.
Color: The Device only outputs color images.
Auto: The Device outputs color images or black-and-white images
according to ambient conditions.
B/W: The Device only outputs black-and-white images.
Sensitivity
Adjust the sensitivity to switch between different modes. There are three
options: Low, Middle, and High.
You can set sensitivity only when Day & Night mode is set to Auto.
Delay
Adjust the delay time to switch between different modes. The value ranges
from 2 s to 10 s.
You can set Delay only when Day & Night mode is set to Auto.
Step 3 Click Save.
5.1.1.1.6 Focus & Zoom
Digital zoom refers to capturing a part of the image to magnify it. The higher the magnification is, the