User's Manual

178
Table 5-54 Description of wiper setting parameter
Parameter
Description
Mode
Set the wiper mode. It is Manual by default.
In Manual mode, you need to manually start the wiper.
Interval Time
The time between wiper starting to wiper ending.
Working Duration
Set the maximum duration of the wiper operating once in Manual
mode. The value ranges from 10 minutes to 1440 minutes.
Step 3 Click Save.
5.7.5 Default
All information except IP address and user management will be restored to defaults. Think twice
before performing the operation.
Select Setting > System > Default, and click Default to restore the Device.
Figure 5-171 Default page
Select the recovery mode.
● Default: All information except IP address and user management will be restored to defaults.
● Factory Default: The function is equivalent to the Reset button of the Device. All configuration
information of the Device can be restored to the factory defaults, and the IP address can also be
restored to the original IP address. After clicking Factory Default, you need to enter the password
of admin user on the page displayed. The Device can be restored to factory defaults only after the
system confirms that the password is correct.
● Only admin user can use this function.
● When the Device is restored to factory defaults, all information except the data in the external
storage media will be erased. Delete data in external storage media by formatting and other
methods.
5.7.6 Import/Export
When multiple devices share the same configuration methods, they can be quickly configured by
importing and exporting configuration files.
Step 1 On the web page of one device, select Setting > System > Import/Export.