User's Manual

156
Figure 5-141 FTP settings
Step 2 Select the Enable checkbox to enable FTP function.
● There might be risks if the FTP function is enabled. Think twice before enabling the
function.
● SFTP is recommended to ensure network security.
Step 3 Configure FTP parameters.
Table 5-47 FTP parameter description
Parameter
Description
Server Address
The IP address of the FTP server.
Port
The port number of the FTP server.
Username
The username to log in to the FTP server.
Password
The password to log in to the FTP server.
Remote Directory
The destination path on the FTP server.
Emergency (Local)
If you enable the function, in case of FTP storage exception, the
recordings and snapshots will be stored on the local SD card.
Step 4 Click test to verify the username and password, and test whether FTP is connected to the
Device.
Step 5 Click Save.
5.6.3.3 Local
SD card information is displayed in the local storage list. You can set it as read only or read & write.
You can also hot swap or refresh it.