User's Manual

97
Figure 5-65 Network PTZ setting
Step 2 Select a protocol.
You can select DH-SD1, DH-SD3, PELCOD, or PELCOP. DH-SD1 is selected by default.
DH-SD1 protocol supports up to 80 presets, and DH-SD3 protocol supports up to 300
presets.
Step 3 Click Save.
5.4.1.2 Analog PTZ Settings
Step 1 Select Setting > PTZ > Protocol > Analog PTZ.
Figure 5-66 Analog PTZ setting
Step 2 Configure analog PTZ parameter.
Table 5-25 Description of analog PTZ parameter
Parameter
Description
Address
Enter the address of the Device.
Make sure that the address is the same as the device address; otherwise you
cannot control the device.
Baud Rate
Select the baud rate of the Device.
Data Bit
It is 8 by default.
Stop Bit
It is 1 by default.
Parity
It is NONE by default.
Step 3 Click Save.