User's Manual

User’s Manual
175
Table 5-53 Description of wiper setting parameter
Parameter
Description
Mode
Set the wiper mode. It is
Manual
by default.
In
Manual
mode, you need to manually start the wiper.
Interval Time
The time between wiper starting to wiper ending.
Working Duration
Set the maximum duration of the wiper operating once in
Manual
mode. The value ranges from 10 minutes to 1440 minutes.
Step 3 Click
Save
.
5.7.5 Default
All information except IP address and user management will be restored to defaults. Think
twice before performing the operation.
Select
Setting
>
System
>
Default
, and click
Default
to restore the Device.
Figure 5-171 Default page
Select the recovery mode.
● Default: All information except IP address and user management will be restored to
defaults.
● Factory Default: The function is equivalent to the Reset button of the Device. All
configuration information of the Device can be restored to the factory defaults, and the IP
address can also be restored to the original IP address. After clicking
Factory Default
, you
need to enter the password of admin user on the page displayed. The Device can be
restored to factory defaults only after the system confirms that the password is correct.
● Only admin user can use this function.
● When the Device is restored to factory defaults, all information except the data in the
external storage media will be erased. Delete data in external storage media by formatting
and other methods.
5.7.6 Import/Export
When multiple devices share the same configuration methods, they can be quickly configured
by importing and exporting configuration files.
Step 1 On the web page of one device, select
Setting
>
System
>
Import/Export
.