User's Manual

User’s Manual
123
Figure 5-96 Plan by preset
Step 3 Click at the upper-right corner of the
Area Config
section.
Double click the rule name to modify it.
Step 4 Click to draw rule box on the video image, and then right-click to complete
drawing.
● After drawing is complete, drag the corners of the drawn area to adjust the
detection area.
● If you select preset plan, 8 detection areas can be drawn at most.
Step 5 Select the check box before the event type to enable the corresponding detection
rule.
Table 5-33 Rule description
Rule
Description
Helmet Detection
When the Device detects person not wearing helmet or not wearing
helmet in the specified color, alarm linkage actions will be performed.
Workwear
Detection
When the Device detects person not wearing workwear in accordance
with the rule, alarm linkage actions will be performed. The rule for
workwear is long-sleeved tops and trousers in the same color. If short-
sleeved shirts, shorts or different colors are detected, it means the rule
is not followed.
Lone Working
Detection
When the Device detects a single person working in the detection
area, alarm linkage actions will be performed.
Absence
Detection
When the Device detects nobody working in the detection area, alarm
linkage actions will be performed.
Step 6 Click next to the detection rule, configure parameters on the
Advanced
Parameter
interface, and then click
Save
.