User's Manual

User’s Manual
118
Parameter
Description
Lock/Unlock
Enter the rule configuration page, and the locking function will be
automatically enabled, and the locking time is 180 s. During this
period, the device cannot track the target. Click
Unlock
to release
the control.
The locking function only takes effect in the rule configuration page.
After switching to the
Live
page, the Device can track the target
normally.
Step 3 Configure tripwire parameter.
Table 5-29 Description of tripwire parameter
Parameter
Description
Period
Set the alarming period to enable alarm events in the defined period.
1. Click
Setting
, and then the
Period
interface is displayed.
2. Enter the time value or press and hold the left mouse button, and
drag directly on the setting interface. There are six periods for
each day. Select the check box next to the period for it to take
effect.
3. Select the day of week (
Sunday
is selected by default; If
All
is
selected, the setting is applied to the whole week. You can also
select the check box next to the day to set it separately).
4. After completing the setting, click
Save
to go back to the rule
configuration interface.
Direction
Configure the tripwire direction. You can select
A->B
,
B->A
or
A<->B
.
Alarm Track
Select the check box, and there will be alarm tracking when a smart
rule is triggered.
Track Time
Set the alarm tracking time.
Record
Select the check box, and when an alarm is triggered, the system will
start recording automatically. Before using the function, you need to
set the recording period of the alarm in
Storage
>
Schedule
, and
select
Auto
for
Record Mode
on the
Record Control
interface.
Record Delay
When the alarm is over, the recording will continue for an extended
period of time. The value range is 10–300 s.
Relay-out
Select the check box, and you can enable the alarm linkage output
port, and link corresponding relay-out devices when an alarm is
triggered.
Alarm Delay
When the alarm is over, the alarm will continue for an extended period
of time. The value range is 10–300 s.
Send Email
Select the
Send Email
check box, and when an alarm is triggered, the
system sends an email to the specified mailbox. You can configure
the mailbox in
Setting
>
Network
>
SMTP (Email)
.
Snapshot
Select the check box, and the system will automatically take
snapshots in case of alarms. You need to set snapshot period in
Storage
>
Schedule
.
Step 4 Click
Save
.