User's Manual

User’s Manual
80
Figure 5-44 SNMP (2)
Step 2 Select SNMP version to enable SNMP.
● Select
V1
, and the system can only process information of V1 version.
● Select
V2
, and the system can only process information of V2 version.
● Select
V3
, and then
V1
and
V2
become unavailable. You can configure
username, password and authentication type. It requires corresponding
username, password and authentication type to access your device from the
server.
Using
V1
and
V2
might cause data leakage, and
V3
is recommended.
In
Trap Address
, enter the IP address of the PC that has MIB Builder and MG-SOFT
MIB Browser installed, and leave other parameters to the default.
Table 5-18 Description of SNMP parameters
Parameter
Description
SNMP Port
The listening port of the software agent on the Device.