User's Manual

ManualsBrandsZhejiang Dahua Vision Technology ManualsCamera & PhotoNETWORK PTZ CAMERA

User’s Manual

Parameter

Description

RTSP Port

Real Time Streaming Protocol port. Keep the default value 554 if it is

displayed. If you play live view through Apple’s QuickTime or VLC, the

following format is available. This function is also supported by

Blackberry mobile phone.

When the URL format requiring RTSP, you need to specify channel

number and bit stream type in the URL, and also username and

password if needed.

When playing live view with Blackberry mobile phone, you need to

disable the audio, and then set the stream encoding mode to H.264B

and resolution to CIF.

URL format example:

rtsp://username:password@ip:port/cam/realmonitor?channel=1&subty

pe=0

● Username: Your username. For example, admin.

● Password: Your password. For example, admin.

● IP: Your device IP. For example, 192.168.1.122.

● Port: Leave it if the value is 554 by default.

● Channel: Channel number starting from 1. For example, if it is

channel 2, then enter channel=2.

● Subtype: stream type. The main stream is 0 (subtype=0); the sub

stream is 1 (subtype=1).

For example, if you require the sub stream of channel 2 from a certain

device, then the URL shall be:

rtsp://admin:admin@192.168.1.123:554/cam/realmonitor?channel=2&

subtype=1

If certification is not required, you do not need to specify the

username and password. Use the following format:

rtsp://ip:port/cam/realmonitor?channel=1&subtype=0

RTMP

A network protocol for real-time data communication. The value is

1935 by default. You can enter the value as needed.

Enable RTMP to push audio and video data to the third-party server.

Make sure that the address is trusted; otherwise it might cause data

leakage.

HTTPS Port

HTTPS communication port. The value is 443 by default. You can set

this parameter as needed.

5000 Port

The port is disabled by default. If you need to connect the Camera to

intelligent transportation box through 5000 port, enable this port.

There might be network risk if the port is enabled. Be cautious.

Step 3 Click

Save

5.2.3 PPPoE

You can enable PPPoE (Point-to-Point Protocol over Ethernet) to establish network

connection. In this case, the Device obtains a dynamic IP address. To use this function, you

need to obtain the PPPoE username and password from the Internet Service Provider (ISP).