User's Manual

User’s Manual
45
Figure 5-9 Day & night settings
Step 2 Configure day & night parameter.
Table 5-3 Description of day & night parameter
Parameter
Description
Type
There are two options:
Electrical
and
ICR
.
ICR
is selected by default.
●
Electrical
Image processing method is used for day & night switch.
●
ICR
: IR filter is used for day & night switch.
Mode
Select a mode from the list (Your selection is independent from the
profile).
Auto
is selected by default.
●
Color
: The Device only outputs color images.
●
Auto
: The Device outputs color images or black-and-white images
according to ambient conditions.
●
B/W
: The Device only outputs black-and-white images.
Sensitivity
Adjust the sensitivity to switch between different modes. There are three
options:
Low
,
Middle
, and
High
.
You can set sensitivity only when
Day & Night
mode is set to
Auto
.
Delay
Adjust the delay time to switch between different modes. The value
ranges from 2 s to 10 s.
You can set
Delay
only when
Day & Night
mode is set to
Auto
.
Step 3 Click
Save
.
5.1.1.1.6 Focus & Zoom
Digital zoom refers to capturing a part of the image to magnify it. The higher the magnification
is, the blurrier the images will become.
Step 1 Select
Setting
>
Camera
>
Conditions
>
Conditions
>
Focus & Zoom
.