User's Manual

User’s Manual
38
Parameter
Description
Contrast
Set the image contrast. The larger the value is, the greater the contrast
will be. The value ranges from 0 to 100.
Saturation
Set the intensity of colors. The larger the value is, the brighter the colors
will be. The value ranges from 0 to 100.
Chroma CNT
The larger the value, the higher suppression on image colors. The value
ranges from 0 to 100.
This parameter takes effect only when the Device is in the environment
with low luminance.
Sharpness
Set the sharpness of picture edges. The larger the value is, the more
obvious the edge will be. The value ranges from 0 to 100.
If the value is too large, there might be image noise. Set the value
according to the actual condition.
Sharpness
CNT
The larger the value is , the stronger the sharpness CNT will be. The
value ranges from 0 to 100.
This parameter takes effect only when the Device is in the environment
with low luminance.
Gamma
Change image brightness through non-linear tuning to expand the
dynamic display range of images. The larger the value is, the brighter the
image will be. The value ranges from 0 to 100.
Flip
Monitoring videos can be flipped over. There are two options.
●
0°
: The monitoring video is normally displayed. It is
0°
by default.
●
180°
: The monitoring video is flipped over.
EIS
Electronic image stabilization (EIS) is used to effectively solve the
problem of image shaking during use, thus presenting clearer images. It
is
Off
by default.
● This function is available on select models.
● This parameter takes effect only when the Device is in the
environment with low luminance.
● Optical image stabilization and electronic image stabilization cannot
be enabled at the same time.
Picture Freeze
After you select
On
, the image at the called preset is displayed directly if
you call a preset or tour, and no images during the rotation of the Device
are displayed.
Step 3 Click
Save
.
5.1.1.1.2 Exposure
You can control the amount of light per unit area reaching the electronic image sensor by
adjusting parameters on the
Exposure
interface.
Step 1 Select
Setting
>
Camera
>
Conditions
>
Conditions
>
Exposure
.