User's Manual

User’s Manual
92
Figure 5-59 P2P page
● P2P is enabled by default. You can manage the devices remotely.
● When P2P is enabled and the device is connected to network, the status is
displayed as
Online
. We might collect the information including IP address, MAC
address, device name, and serial number. The information collected is for remote
access only. If you do not agree with this, you can clear the
Enable
check box.
Step 2 Log in to mobile phone client, and then tap
Device Management
.
Step 3 Tap
Add +
at the upper-right corner.
Step 4 Scan the QR code on the P2P page.
Step 5 Follow the onscreen instructions to finish settings.
5.2.15.2 ONVIF
The ONVIF authentication is
On
by default, which allows the network video products (including
video recording device and other recording devices) from other manufacturers to connect to
the service.
Step 1 Select
Setting
>
Network
>
Access Platform
>
ONVIF
.
Figure 5-60 ONVIF page
Step 2 Select
On
for
Authentication
.