User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Configuration Flow
- 3 Device Initialization
- 4 Setting
- 4.1 Device Login
- 4.2 Local
- 4.3 Camera
- 4.4 Network
- 4.5 PTZ
- 4.5.1 Configuring Presets
- 4.5.2 Configuring Tour
- 4.5.3 Configuring Scan
- 4.5.4 Configuring Pattern
- 4.5.5 Configuring Pan
- 4.5.6 Configuring PTZ Speed
- 4.5.7 Configuring Idle Motion
- 4.5.8 Configuring Power Up
- 4.5.9 Configuring PTZ Rotation Limit
- 4.5.10 Configuring Scheduled Task
- 4.5.11 Configuring PTZ Maintenance
- 4.5.12 Configuring Protocol
- 4.6 Event
- 4.7 Storage
- 4.8 System
- 4.9 System Information
- 4.10 Setting Log
- 5 Live
- 6 Record
- 7 Picture
- 8 AI
- 9 Security
- 10 Report
- Appendix 1 Cybersecurity Recommendations
68
Figure 4-59 Alarm linkage
Step 3 Select an alarm-in port and a sensor type.
●
Anti-Dither
: Only record one alarm event during the anti-dither period.
●
Sensor Type:
NO
or
NC
.
Step 4 Select the schedule and arming periods and alarm linkage action. For details, see "4.6.1.2
Alarm Linkage".
If the exiting schedules cannot meet the scene requirement, you can click
Add Schedule
to add new schedule. For details, see "4.6.1.2.1 Adding Schedule".
Step 5 Click
Apply
.
4.6.1.2 Alarm Linkage
When configuring alarm events, select alarm linkages (such as record, snapshot). When the
corresponding alarm is triggered in the defined arming period, the system will trigger alarm linkage.
Select >
Event
>
Alarm
, and then click next to
Enable
to enable alarm linkage.