User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Configuration Flow
- 3 Device Initialization
- 4 Setting
- 4.1 Device Login
- 4.2 Local
- 4.3 Camera
- 4.4 Network
- 4.5 PTZ
- 4.5.1 Configuring Presets
- 4.5.2 Configuring Tour
- 4.5.3 Configuring Scan
- 4.5.4 Configuring Pattern
- 4.5.5 Configuring Pan
- 4.5.6 Configuring PTZ Speed
- 4.5.7 Configuring Idle Motion
- 4.5.8 Configuring Power Up
- 4.5.9 Configuring PTZ Rotation Limit
- 4.5.10 Configuring Scheduled Task
- 4.5.11 Configuring PTZ Maintenance
- 4.5.12 Configuring Protocol
- 4.6 Event
- 4.7 Storage
- 4.8 System
- 4.9 System Information
- 4.10 Setting Log
- 5 Live
- 6 Record
- 7 Picture
- 8 AI
- 9 Security
- 10 Report
- Appendix 1 Cybersecurity Recommendations
59
4.5.2 Configuring Tour
Configure Tour and the PTZ camera repeats performing tours among the configured presets after
configuration.
Prerequisites
You need to setup several preset points in advance.
Procedure
Step 1 Click and then select
PTZ
>
Tour
.
Step 2 Click
Add Tour Group
, and then double click
Name
to change the name of tour.
Step 3 Select tour group and then select the presets from the
Preset Point
drop-down list on the
left.
Repeat this step to add several presets for the tour group.
Step 4 Configure
Stay Time(S)
and
Speed
to set the stay time of the Camera at the preset point
and its rotating speed.
Stay time is measured in seconds. The value ranges from 15 seconds to 3600 seconds.
Figure 4-49 Tour group
Step 5 Select Tour mode.
●
Original Path: The camera rotates in the order of selected preset points.
●
Shortest path: The camera rearranges the preset points according to distance, and then
rotates them according to the shortest path.
This function is available on select models.
Step 6 Click
Apply
to complete settings.
Step 7 Click to start tour.
●
The ongoing tour stops if any operation is made to the PTZ.
●
Click to stop tour.