User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Configuration Flow
- 3 Device Initialization
- 4 Setting
- 4.1 Device Login
- 4.2 Local
- 4.3 Camera
- 4.4 Network
- 4.5 PTZ
- 4.5.1 Configuring Presets
- 4.5.2 Configuring Tour
- 4.5.3 Configuring Scan
- 4.5.4 Configuring Pattern
- 4.5.5 Configuring Pan
- 4.5.6 Configuring PTZ Speed
- 4.5.7 Configuring Idle Motion
- 4.5.8 Configuring Power Up
- 4.5.9 Configuring PTZ Rotation Limit
- 4.5.10 Configuring Scheduled Task
- 4.5.11 Configuring PTZ Maintenance
- 4.5.12 Configuring Protocol
- 4.6 Event
- 4.7 Storage
- 4.8 System
- 4.9 System Information
- 4.10 Setting Log
- 5 Live
- 6 Record
- 7 Picture
- 8 AI
- 9 Security
- 10 Report
- Appendix 1 Cybersecurity Recommendations
38
Figure 4-30 Edit command
4. Restart the camera.
5. Check the PC command line, if information such as
Reply from 192.168.0.125…
is displayed, the
configuration succeeds.
6. Enter
http://(IP address)
in the browser address bar to log in.
4.4.2 Port
Configure the port numbers and the maximum number of users (includes web, platform client and
mobile phone client) that can connect to the device simultaneously.
Step 1 Select >
Network
>
Port
.
Step 2 Configure port parameters.
●
The configuration of
Max Connection
,
RTSP Port
,
RTMP Port
,
HTTPS Port
take effect
immediately, and others will take effect after reboot.
●
0–1024, 1900, 3800, 5000, 5050, 9999, 37776, 37780–37880, 39999, 42323 are occupied
for specific uses, do not use them.
●
Do not use the same value of any other port during port configuration.